-
×
Epic Bait Molds 3" NED STINGER MOLD - 8 CAVITY
1 × $135.00
Subtotal: $135.00
3.5″ craw comes standard with legs.
Single Cavity
by Kearby Design & Manufacturing LLC
Made in USA
| Weight | 1.5 lbs |
|---|---|
| Dimensions | 6 × 1 × 3 in |
Related products
Aluminum Fishing Lure Molds
$145.00
The 5 Inch Flappin Drax bait has a total length of 5 inches, body width of .8″ (including ribs), and body thickness of .46″ (including ribs). There are a total of 10 ribs along the body and the last two near the tail of the bait are recessed (slightly indented) to accommodate the hook point. The bait is also […]
Out of stock
Out of stock
Aluminum Fishing Lure Molds
$189.99
The 2 Inch Sandworm bait measures 2″ from end to end and the bait’s round/ribbed body section measures .215″ wide x .175″ tall at the thickest part. The tiny projections/legs along the sides of the body are flat on one side, rounded on other and taper to a point. This allows for lots of movement […]
Out of stock
Aluminum Fishing Lure Molds
$159.99
The 3 Inch Epic PreyBait, “hand injection” style mold was designed as part of a collaboration with Marling Baits. The Epic PreyBait is a boot tail swimbait with a rear fin designed to have an intense action with realistic presentation at any speed, with a kick and wobble on the fall. This bait/mold does not have a hook slot and is intended to […]
Out of stock
Out of stock
Aluminum Fishing Lure Molds
$160.00
The ned craw bait measures 2.5″ from tail to tip of claws. Featuring 3D claws, short ned rig style body, 6 legs, and small antenna. 4 cavity
Aluminum Fishing Lure Molds
$169.99
The 9 Inch Pintail Worm is 9 inches total length with a diameter of .35″ at the thickest part of the body that tapers down to .125″ in diameter at the tip of the tail. The taper of the bait starts behind the egg sack area to leave the front of the bait thick where the hook […]