-
×
Epic Bait Molds 2" Sand Worm
1 × $189.99 -
×
Epic Bait Molds 5 INCH JERK MOLDS - 6 CAVITY
1 × $185.00
Subtotal: $374.99
3.5″ craw comes standard with legs.
Single Cavity
by Kearby Design & Manufacturing LLC
Made in USA
| Weight | 1.5 lbs |
|---|---|
| Dimensions | 6 × 1 × 3 in |
Related products
Aluminum Fishing Lure Molds
Epic Bait Molds 3″ SLICK SWIM PADDLE TAIL SWIMBAIT (NO HOOK SLOT) – 6 CAVITY TOP SHOOT
$190.00
The 3″ slick swimmer paddle tail swimbait’s body is just under .5″ thick and .375″ wide. The bait has a big side to side tail wobble with body roll at slow speeds and ultra fast, hard kicking action at higher speeds. This is a 6 cavity “top shot” mold which allows you to use two injectors […]
Aluminum Fishing Lure Molds
$189.99
The 2 Inch Sandworm bait measures 2″ from end to end and the bait’s round/ribbed body section measures .215″ wide x .175″ tall at the thickest part. The tiny projections/legs along the sides of the body are flat on one side, rounded on other and taper to a point. This allows for lots of movement […]
Aluminum Fishing Lure Molds
$165.99
The ned craw bait measures 2.5″ from tail to tip of claws. Featuring 3D claws, short ned rig style body, 6 legs, and small antenna. 4 cavity
Out of stock
Out of stock
Aluminum Fishing Lure Molds
$159.99
The 3 Inch Epic PreyBait, “hand injection” style mold was designed as part of a collaboration with Marling Baits. The Epic PreyBait is a boot tail swimbait with a rear fin designed to have an intense action with realistic presentation at any speed, with a kick and wobble on the fall. This bait/mold does not have a hook slot and is intended to […]
Aluminum Fishing Lure Molds
$185.00
This “fluke style” or “jerk bait” style bait measures 5 inches from nose to tail with a body width of .38″ and a mid body thickness of .6″. The belly features a deep hook slot to allow great hookup ratios on ewg style hooks. The back features a divot down the center for aligning and […]
Aluminum Fishing Lure Molds
$135.00
The 3 Inch Stinger Ned measures 3" from tip to tail and the thick end of the bait is .45" thick. The body has a thin angled rib texture and a pointed, pyramid shaped tail. Designed for use with a ned rig style jig heads.
Mold size - 7in x 3in Number of cavities - 8 Made in the USA from 6061 Aluminum
Aluminum Fishing Lure Molds
$135.00
The Stinger Ned measures 3″ from tip to tail and the thick end of the bait is .45″ thick. The body has a thin angled rib texture and a pointed, pyramid shaped tail. Designed for use with a ned rig style jig heads. Mold size – 7in x 3in Number of cavities – 8 Made in […]